Add new Gateway and Lock to Account (iOS)

The aim of this article is to show, how you can add a new KleverKey Gateway and Lock with the KleverKey iOS App. 

Prerequisites

• Download KleverKey App and create an account
• Plug KleverKey Gateway into a power source (use only the included power supply) and mount it next to the lock (range typically 2-10m, depending on environment)
• The LED should blink with blue color.

Add Gateway

• Log in to the KleverKey app
• Select the Gateway tab
• Tap on the plus sign in the top right corner and choose the correct Gateway (compare the Gateway ID which can be found on the Gateway)
• Fill in the demanded information and if the LED on your Gateway blinks green, it is successfully connected to your Wifi. (If it blinks yellow it fails to connect to the Wifi and you should repeat this step). See Gateway Status LED for more information.

Add a Lock

• Log in to the KleverKey Portal
• Select "Hardware" -> "Locks"
• Tap on the plus sign in the bottom right corner, choose "Add Lock" and fill in the information.
• Tap on the newly added lock and choose "Link Lock" on the left side. Make sure you link the lock to a gateway which was already added to your account. Note: You can link up to two locks to a Gateway
• Now your lock is connected to your gateway and you can grant permission with the Kleverkey Portal

Optionally: Grant a Permission

• Log in to the KleverKey Portal
• Select "Hardware" -> "Locks"
• Choose the lock you want to grant permission to
• Select "Grant permission" and fill in the information
• If a user is not yet registered, you'll be forwarded to the invite user workflow
• User will instantly receive the permission after "grant" is clicked
• Switch to the "Events" tab to monitor the lock events